製品情報

DR1S2-5307V4V(300W)

製品種別 電源 (Zippy)
電源の種類 N+1 Redundant DC
製品説明

製品仕様

wattage 300W
solution Server ,Workstation ,Storage System ,IPC ,Communication ,Networking
dimension_mm 275.5x135x83.1
dimension_inch 10.85x5.31x3.27
input_spec VOLTAGE:-36 ~ -72VDC (NORMAL -48VDC) FREQUENCY: DCSTEADY-STATE CURRENT: 12A/6A MAXIMUN AT ANY LOW/HIGH RANGE INPUT VOLTAGEINRUSH CURRENT: 70A MAX. @-48VDC INPUT (AT 25DEGREES AMBIENT COLD START)
dc_output Output VoltageOutput Current Min.Output Current Max.Regulation LoadRegulation LineOutput Ripple & Noise Max.[P-P]+5V10.520±5%±1%50mV+5V20.520±5%±1% 120mV +12V2.024±5%±1%120mV-12V0.10.5±10%±1%50mV+5VSB0.12.5±5%±1%50mV
* POWER MODULE TOTAL OUTPUT POWER OF +5V AND +3.3V NOT EXCEED 140W
* TOTAL OUTPUT MAX 380W
* WHEN CONDITIONS OF BOTH +5V/0A & +3.3V/0A, MIN LOAD OF 4A AT +12V IS A MUST


features * TEMPERATURE RANGE:OPERATING 0℃~50℃, STOREAGE -20℃~80℃
* HOLD UP TIME:1.6mS MIN.
* EFFICIENCY: TYPICAL >80% AT -48VDC, FULL LOAD
* OVER POWER PROTECTION: 110~160%
* OVER VOLTAGE PROTECTION:+5V1→5.6V~6.7V,+5V2→5.6V~6.7V,+12V→13V~17V
* SHORT CIRCUIT PROTECTION: +5V1, +5V2, +12V, -12V
* REMOTE ON/OFF CONTROL
* REMOTE SENSING DESIGN
* BALANCE LOAD SHARING DESIGN
* HOT-SWAPPABLE/HOT PLUGGABLE REDUNDANCY FUNCTION
* FAULTY ALARM METHODS: LED, BUZZER, TTL SIGNAL
* SAFETY:MEET UL, CUL, TUV, CCC


*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.