BP1H-6300F(300W)
| 製品種別 | 電源 (Zippy) |
|---|---|
| 電源の種類 | 1U Single DC |
| 製品説明 |
製品仕様
| wattage | 300W |
|---|---|
| solution | Label |
| dimension_mm | 225x100x40.5 |
| dimension_inch | 8.85x3.94x1.59 |
| input_spec | VOLTAGE： DC 20V～28V INPUT CURRENT：20.0A (RMS) FOR 24 VDC INRUSH CURRENT：20.0A MAX. |
| dc_output |
|
| features | *TEMPERATURE RANGE：OPERATING -10℃～40℃ * HUMIDITY:OPERATING:20%-95%, NON-OPERATING:10%-95% * REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS *HOLD UP TIME：1.6mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE *DIELECTRIC WITHSTAND：INPUT/OUTPUT 1500 VAC FOR 1 SECOND INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND *EFFICIENCY：65% TYPICAL，AT FULL LOAD *POWER GOOD SIGNAL：ON DELAY 100mS TO 500mS *OVERLOAD PROTECTION：130±20% *OVER VOLTAGE PROTECTION：+5V→5.5V～7.0V , +3.3V→4.0V～4.5V *SHORT CIRCUIT PROTECTION：+5V +12V +3.3V *EMI NOISE FILTER : FCC CLASS A, CISPR22 CLASS A *SAFETY : UL 60950, CSA 22.2 IEC60950, TUV EN60950 *REMOTE ON/OFF CONTROL THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY). AS LOGIC LEVEL IS LOW，OUTPUTS VOLTAGE WERE ENABLE AS LOGIC LEVEL IS HIGH，OUTPUTS VOLTAGE WERE DISABLE *COOLING :Two 40mm DC FANS *THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS. |
| MTBF:http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/MTBF/BP1H-6300F.pdf MTBF(RoHS):http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/MTBF/BP1H-6300F(RoHS).pdf CCC:http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/CCC/BP1H-6300F%20CCC.pdf CE(Radiation):http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/CE/BP1H-6300F%20(+Radiation).pdf |
