P1N-6257P(257W)
製品種別 | 電源 (Zippy) |
---|---|
電源の種類 | 1U Single |
製品説明 |
製品仕様
wattage | 257W |
---|---|
solution | Server ,Workstation ,Storage System ,IPC ,Communication ,Networking |
dimension_mm | 208x79x40 |
dimension_inch | 8.19x3.11x1.57 |
input_spec | ‧VOLTAGE: 90 ~ 264 VAC FULL RANGE. ‧FREQUENCY: 47 ~ 63 Hz. ‧INPUT CURRENT: 3A (RMS) FOR 230 VAC 6A (RMS) FOR 115 VAC ‧INRUSH CURRENT: 90A MAX. FOR 115 VAC 140A MAX. FOR 230 VAC |
dc_output |
|
features | ‧TEMPERATURE RANGE: OPERATING 0℃ --- 40℃ ‧HOLD UP TIME: 16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE ‧DIELECTRIC WITHSTANDING: INPUT/OUTPUT 1500 VAC FOR 1 MINUTE INPUT TO FRAM GROUND 1500 VAC FOR 1 MINUTE ‧EFFICIENCY: 68% TYPICAL, AT FULL LOAD ‧POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms ‧OVER LOAD PROTECTION: 130% +/- 20% ‧OVER VOLTAGE PROTECTION: +5V→5.7V~6.2V, 3.3V→3.7V~4.1V, +12V→13.3V~14.3V ‧SHORT CIRCUIT PROTECTION: +5V -5V +12V -12V +3.3V ‧EMI NOISE FILTER: FCC CLASS B/A, CISPR22 CLASS B/A ‧SAFETY: MEET UL 60950-2, CSA 60950-2, TUV EN-60950-2 ‧REMOTE ON / OFF CONTROL THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY) AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE ‧3.3V / 5V REMOTE SENSING ‧MEET IEC-1000-3-2 CLASS D ‧COOLING: 40 mm DC FANS *THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS. |
TUV:http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/TUV/P1N%20TUV.pdf CB:http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/CB/P1N%20CB.pdf CCC:http://www.zippy.com.tw//backend/DownLoad/DownLoad/Power/ |