製品仕様
| Product SKUs | |
|---|---|
| SYS-1026TT-IBQF | SuperServer 1026TT-IBQF (Black) |
| Motherboards | |
| Motherboards | Super X8DTT-IBQF |
| Processor/Cache | |
| CPU | Dual 1366-pin LGA Sockets Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below: Intel® Xeon® Processor X5600/E5600/L5600 Series (Westmere) 40W - 130W Intel® Xeon® Processor X5500/E5500/L5500 Series (Nehalem-EP) 38W - 95W |
| QPI | up to 6.4 GT/s |
| System Memory | |
| Memory Capacity | 12x 240-pin DIMM slots Supports up to 192 GB** 1333 / 1066 / 800MHz DDR3 ECC Registered memory Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory Memory Mirroring supported |
| Memory Type | 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs |
| DIMM Sizes | 1GB, 2GB, 4GB, 8GB**, 16GB** |
| Memory Voltage | 1.5 V / 1.35 V |
| Error Detection | Corrects single-bit errors Detects double-bit errors (using ECC memory) Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
| On-Board Devices (per Node) | |
| Infiniband | Mellanox ConnectX-2 QDR Infiniband 40Gbps Controller |
| Chipset | Intel® 5520 (Tylersburg) chipset ICH10R + IOH-36D |
| SATA | Intel ICH10R SATA 3.0Gbps Controller RAID 0, 1, 5, 10 support |
| IPMI | Support for Intelligent Platform Management Interface v.2.0 IPMI 2.0 with virtual media over LAN and KVM-over-LAN support Nuvoton WPCM450 BMC |
| Network Controllers | Intel® 82576 Dual-Port Gigabit Ethernet Controller Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output Intel® I/OAT 3 support for fast, scaleable, and reliable networking VMDq support for better performance of virtualization 1x Realtek RTL8201N PHY (dedicated IPMI) |
| Graphics | Matrox G200eW 16 MB DDR2 |
| Super I/O | Winbond W83527HG chip |
| Clock Generator | 932S421 chip |
| Input / Output (per Node) | |
| Serial ATA | Six Serial ATA ports Six SATA hard drives supported |
| LAN | 2x RJ45 LAN ports 1x RJ45 Dedicated IPMI LAN port |
| USB | 2 rear + 1 header (2 Ports) 4 total USB ports, 2.0 Compliant / 1.1 Compliant |
| VGA | 1x VGA Port |
| Serial Port | 1 Fast UART 16550 serial port |
| Infiniband | 1 External QSFP Infiniband Connector |
| System BIOS (per Node) | |
| BIOS Type | 32Mb SPI Flash EEPROM with AMI® BIOS |
| BIOS Features | Plug and Play (PnP) PCI 2.2 ACPI up to 3.0 USB Keyboard support |
| Chassis | |
| Form Factor | 1U Rackmount |
| Model | CSE-809TQ-1200B |
| Dimensions | |
| Height | 1.7" (43mm) |
| Width | 17.2" (437mm) |
| Depth | 27.75" (705mm) |
| Gross Weight | 40 lbs (18.1kg) |
| Available Colors | Black |
| Front Panel (per Node) | |
| Buttons | Power On/Off button System Reset button |
| LEDs | Power LED Hard drive activity LED 2x Network activity LEDs System Overheat LED |
| Expansion Slots (per Node) | |
| PCI-Express | 1 (x16) PCI-E ( Low Profile) |
| Drive Bays (per Node) | |
| Hot-swap | 4x 2.5" SATA Hot-swap drive bays |
| SATA Backplane | |
| SATA Backplane | 1U SATA Backplane |
| System Cooling | |
| Fans | 6x Cooling Fans |
| Power Supply | |
| Power Supply | 1200W high-efficiency power supply with PMBus |
| AC Input | 1000W Output @ 100-140V, 11.5-8A, 50-60Hz 1200W Output @ 180-240V, 8-5.5A, 50-60Hz |
| DC Output | 1000W: +12V/83A; +5Vsb/4A 1200W: +12V/100A; +5Vsb/4A |
| Certification |  Gold Certified [ Test Report ] |
| Management | |
| Software | IPMI (Intelligent Platform Management Interface) v1.5 / 2.0 with KVM support SuperDoctor® III Watch Dog NMI |
| Power Configurations | ACPI Power Management Main Switch Override Mechansim Power-on mode for AC power recovery |
| PC Health Monitoring | |
| CPU | Monitors for CPU Cores,+1.5V, +3.3V, +5V, +12V, +5 Stdby, +3.3 Stdby, VBAT, Memory Voltages. CPU Core 6-Phase-switching voltage regulator |
| FAN | Total of four 4-pin PWM fans 4x fans with tachometer monitoring Status monitor for speed control Status monitor for on/off control Low noise fan speed control |
| Temperature | Monitoring for CPU and chassis environment CPU thermal trip support Thermal Control for 4x Fan Connectors PSU I2C temperature sensing logic Thermal Monitor 2 (TM2) support PECI |
| LED | Power Fail / Overheat LED Suspend-state Indicator LED UID LED |
| Other Features | SDDC Support |
| Operating Environment / Compliance | |
| RoHS | RoHS Compliant |
| Environmental Spec. | Operating Temperature: 10° to 35° C (50° to 95°F) Non-operating Temperature: -40° to 70° C (-40° to 158° F) Operating Relative Humidity: 8% to 90% (non-condensing) Non-operating Relative Humidity: 5 to 95% (non-condensing) |
ご注文から納品までの流れ「発注方法がわからない」「納品までの流れがイメージできない」そんな不安を解消いたします！
-
お問い合わせ
まずは、お電話またはお問い合わせフォームよりご連絡ください。
ご希望のサーバーやシステム構成、導入目的、台数、納期などについて、ヒアリングさせていただきます。以下の情報をお知らせいただければ、スムーズに製品提案が可能でございます。
・CPU (コア数,クロック数)
・メモリ (容量)
・ストレージ (SSD/HDD,SATA/SAS/NVMe, 容量, 本数)
・OS
・GPU等拡張カードの有無
・I/Oポート仕様
・保証期間 (センドバック対応が標準です。オンサイト保守をご希望の際はご指示ください。)
・希望納期お問い合わせ先
Tel：03-3815-9001
URL：https://www.sunwaytech.co.jp/contact/ -
ご提案・お見積り
お客様のニーズに合った最適なサーバーや構成をご提案し、お見積書を作成いたします。
技術的なご質問やカスタマイズのご要望にも柔軟に対応いたしますので、お気軽にご相談ください。 -
ご注文
お見積り内容にご納得いただけましたら、ご注文書をご提出ください。
ご注文後、正式な納期や手配状況をご案内いたします。 -
入荷検査・キッティング
海外メーカーよりサーバーが入荷後、弊社にて検品および動作確認を行います。
ご要望に応じて、初期設定やOSのインストールなども承ります。 -
納品
ご指定の場所へサーバーを発送いたします。
納品時に万が一トラブルが発生した場合も、迅速にサポートいたします。 -
アフターサポート
納品後も安心してご利用いただけるよう、サポート体制を整えております。
ご購入者様向けの会員サイトからRMA申請・修理状況の確認が可能です。サポート窓口
Tel：03-3815-9001
URL：https://member.sunwaytech.co.jp/login安心・確実なサーバー導入をサポートいたします！
まずはお気軽にお問い合わせください。
CLOSE
